PREPPING, MADE FRIENDLY

SURVIVAL GUIDES · CHECKLISTS · GEAR

@alienbunker on Pinterest

Emergency Door Draft Stoppers: Stop the Cold Leaking Under Your Door

Portable power station and solar panel keeping a home lit during a blackout

A draught under the door is a small thing, and it is easy to ignore — until the heating is off, the power is out, or a cold snap arrives, and suddenly that thin gap under the door is letting in a steady stream of freezing air. In a small flat, one draughty door can make the difference between a room that stays warm and a room that does not. A door draft stopper is one of the cheapest, simplest fixes in the whole emergency kit: a long, heavy cushion that sits against the bottom of the door and blocks the gap. It costs very little, it needs no tools, and it works the moment you put it down. This guide covers what draft stoppers are, how to make one, and where to use them.

Bought vs. homemade: a quick comparison

Option Cost How well it works Best for
Bought fabric draft stopper Low Good — heavy, shaped to the door, stays put The front door and the main living-room door
Foam or brush door seal Low Very good — sticks to the door and seals every time it closes Doors you open and close often
Rolled towel Free Fair — works, but slips and needs re-rolling Right now, in an emergency, with no shops open
Homemade fabric tube Almost free Good — as good as a bought one if it is heavy enough Every door in the flat, made in an afternoon
Self-adhesive foam tape Low Good on the sides and top of the door frame Gaps around the frame, not just under the door

The rule is simple: the heavier the stopper, the better it works. A light cushion gets pushed aside every time the door opens. A heavy one — filled with sand, rice, or old clothes packed tight — stays where you put it. If you buy one, choose a stopper that is at least as long as the door is wide, and heavy enough that you can feel the weight when you pick it up. If you make one, use an old pair of tights, a rolled-up towel inside a pillowcase, or a length of fabric sewn into a tube and filled with dry rice or sand — and make it slightly longer than the door, so the ends curl up against the frame and seal the corners too.

Where to put them, and the mistakes to avoid

Start with the front door, because that is where most of the cold air comes in. Then do the door of the room you live in during a blackout or a cold snap — the room you are heating, if you are heating one room at a time, as in our keeping warm without heating guide and our winter blackout guide. Then do the balcony door, which is often the draughtiest door in the flat, and any door to a cold hallway or a storage room. A draft stopper works best as part of a set of cold-weather measures: cover the windows with insulation film, close the curtains at night, and block the draughts — see our window insulation film guide and our storm window guide. The common mistakes are easy to avoid: using a stopper that is too light, so it slides away; forgetting the balcony door, which is often the worst one; and blocking a door that needs to open quickly in an emergency — a draft stopper should slow the air, not trap you in a room, so never fix one to a door with nails or glue, and make sure everyone in the household can move it easily. And if you use a fuel heater, remember that a sealed room needs ventilation: a draft stopper keeps the cold out, but a heater needs fresh air, so follow the safety rules in our portable heater safety guide. A door draft stopper is a small thing. In a cold flat, on a cold night, it is the difference between a room that holds its heat and a room that leaks it out under the door.

Shop door draft stopper basics

As an Amazon Associate, Alien Bunker earns from qualifying purchases. This page contains affiliate links, which support the site at no extra cost to you.