A water heater is the kind of appliance you forget about until it stops working — and when it does, it makes itself known in a hurry. Either there is no hot water on a cold morning, or worse, there is water where it should not be: spreading across the bathroom floor, dripping through a ceiling, or pooling under the unit. In a rented apartment, a water heater problem is also a landlord problem, but the first ten minutes belong to you. What you do in those ten minutes decides whether it is a small repair or a flooded flat.
Leaking heater: stop the water first
If the heater is leaking, the first job is to stop the water. Find the shut-off valve for the heater — usually a tap on the cold water pipe feeding into the unit — and turn it off. If you cannot find it, or it is stuck, shut off the main water supply to the flat instead. Then switch off the power to the heater: flip its breaker in the fuse box for an electric heater, or turn the gas supply off for a gas heater. Never touch electrical switches or the heater itself if you are standing in water — water and electricity together can kill, so step back, dry your feet, and call for help from a safe spot. Mop up the water as best you can and move anything valuable out of the way, especially electronics and anything on the floor below the leak. Then contact the landlord or management company straight away, because a leaking heater is their repair, not yours, and the longer it waits the worse the damage gets. Use the contacts list in our landlord contacts plan and report the problem in writing as well as by phone, with photos of the leak and the water damage. Do not try to open the heater, drain it, or fix the leak yourself — water heaters hold pressurised hot water, and a wrong move can cause burns or make the leak worse. Your job is to stop the water, stop the power, protect the flat, and call the right people.
No hot water: what to check before you call
No hot water is less urgent than a leak, but it still needs sorting, and a few simple checks can save a needless call-out. First, check whether other taps are affected: if every tap is cold, the heater is the problem; if only one tap is cold, the problem is more likely the tap itself. For an electric heater, check the breaker — a tripped breaker is a common cause, and flipping it back on may fix it, but if it trips again, leave it off and call for help. For a gas heater, check whether the gas supply is on and whether other gas appliances work; a pilot light that has gone out is a common cause, but relighting a pilot light is a job for the landlord’s technician, not a tenant, unless the heater’s own instructions clearly describe how to do it safely. Check the thermostat or temperature setting too — a setting that has been knocked down to minimum will produce lukewarm water that feels like no hot water at all. If none of these checks fixes it, report it to the landlord with the same details as a leak: what happened, when it started, and what you have already checked. While you wait for the repair, plan for the gap: a kettle can heat water for washing, a gym or a public bath can cover showers, and a few bottles of stored water cover drinking and cooking, as in our water storage guide. And if the heater problem happens during a power cut, the rules change again — see our blackout safety checklist for what to do when the power, not the heater, is the problem. A water heater emergency is rarely dangerous if you act fast and stay out of the way of the water, but it is almost always expensive if you ignore it. Ten minutes of the right actions now saves days of drying out later.
Shop water heater emergency basics
- Water leak detector alarms — a beep that catches a leak before it becomes a flood.
- Adjustable pipe wrenches — turn a stuck shut-off valve when you need to.
- Absorbent water dam socks — soak up a leak and keep it from spreading.
As an Amazon Associate, Alien Bunker earns from qualifying purchases. This page contains affiliate links, which support the site at no extra cost to you.
